Marshall Stamping FVAW Foundation Vent Area Wall 12 Inchby Marshall Stamping
- Rolled top on all standard area walls
- Stamped from single steel sheet
- Bright finish reflects light into basement
- Holes in flanges for bolting to wall
- Deep corrugation stiffens against back fill
- Minimum G60 galvanized coating
- All back filling should be done gradually to prevent excessive pressure against area wall
- Grating type admits maximum light and air into basement
Standard width area walls galvanized steel round ht 12 inches Rounded bottom corners for extra safety. Stamped from single steel sheet. Bright finish reflects light into basement. Hole in flanges for bolting to wall. Deep corrugation stiffens against back fill. All back filling should be done gradually to prevent ex cessive pressure against area wall. 19- 1/2 inches Wdth. x 10 inches Dpth.
- Part Number
- Related Departments
- HardwareBuilding MaterialsBuilding Exterior HardwareWindow Wells & Covers
- Shipping Weight
- 18.22 pounds
- Domestic Shipping
- Item is restricted to ground only shipping methods.
- International Shipping
- Currently, this item can only be shipped within the Contiguous United States (Lower 48).