Marshall Stamping AWR24/683 24 Inch Standard Area Wall Galvanized (Case of 5)

Key Features

• Rolled top on all standard area walls
• Stamped from single steel sheet
• Bright finish reflects light into basement
• Holes in flanges for bolting to wall
• Deep corrugation stiffens against back fill
• Minimum G60 galvanized coating
• All back filling should be done gradually to prevent excessive pressure against area wall

Standard width area walls - galvanized steel - round - rolled edge - 37 inches wide by 16 inches deep - 24 inches height - 22 gauge Stamped from single steel sheet with rolled edges for added safety. Bright finish reflects light into basement. Holes in flanges for bolting to wall. Deep corrugation stiffens against back fill. All back fill should be done gradually to prevent excessive pressure against area wall. 37 inch width by 16 inch depth.

Stamped from single steel sheet with rolled edges for added safety. Bright finish reflects light into basement. Holes in flanges for bolting to wall. Deep corrugation stiffens against back fill. All back fill should be done gradually to prevent excessive pressure against area wall. 37 in W x 16 in D. Stamped from single steel sheet with rolled edges for added safety. Bright finish reflects light into basement. Holes in flanges for bolting to wall. Deep corrugation stiffens against back fill. All back fill should be done gradually to prevent excessive pressure against area wall. 37 inches Wdth. x 16 inches Dpth.