Titebond 6202 Instant Bond Wood Adhesive Thin 4 Ounce
Rapid Ship
- Buy 10 for $21.00 each and save 24%
- Buy 40 for $20.74 each and save 25%
Key Features
- Fast set, eliminates clamping or reduces clamp time
- Bonds stronger than wood
- Excellent heat and solvent resistance
- Unaffected by finishes
- Triple distilled for purity and consistency
- Impact-resistant
- No-clog applicator for easy use and waste reduction
Wood adhesive instant bond interior - thin viscosity size 4 ounces Provides a strong, permanent bond. Ideal for hard to reach joints or surface areas that are difficult to clamp, for repairing hair line cracks and small defects in wood and repairing loose veneer edges. Also can be used as a finish. Designed primarily for wood and wood products. Also effective on a wide variety of materials and substrates. 5 cps viscosity offers an assembly time of 5 seconds and an initial cure speed of 3 seconds. NOT intended for Exterior use or where moisture is likely. MIL Spec (A46050 C) Type II, Class 1. Between 2800 and 4200 psi shear strength at room temperature depending on substrate tested.
Titebond instant bond is a two-part bonding system that takes between 5 to 15 sec to set and 30 to 60 sec for initial cure. It provides a strong, permanent bond and is ideal for hard to reach joints or surface areas that are difficult to clamp. Designed primarily for wood and wood products, this adhesive is also very effective on a wide variety of materials and substrates. Titebond instant bond thin viscosity product offers the fastest assembly time of 5 sec and an initial cure speed of 3 sec. It is ideal for repairing hair line cracks and small defects in wood, as well as repairing loose veneer edges. It can also be used as a finish. While Titebond instant bond activator can be used to further reduce set times, it is not required for producing strong, tight-fitting joints. Provides a strong, permanent bond. Ideal for hard to reach joints or surface areas that are difficult to clamp, for repairing hair line cracks and small defects in wood and repairing loose veneer edges. Also can be used as a finish. Designed primarily for wood and wood products. Also effective on a wide variety of materials and substrates. 5 cps viscosity offers an assembly time of 5 seconds and an initial cure speed of 3 seconds. NOT intended for Exterior use or where moisture is likely. MIL Spec (A46050 C) Type II, Class 1. Between 2800 and 4200 psi shear strength at room temperature depending on substrate tested.