Dremel 426 Fiberglass Cut Off Wheel

Key Features

• May also be used on other materials including thin wood, plastics and ceramics
• Cut bolts or screws or make slots in rusted or stripped bolts and screws
• The cut-off wheel cuts only along its edge
• The cut-off wheel cuts only along its edge
• Do not attempt to sand or cut curved holes with them
• Secure objects to a stable surface while working
• Hold the tool so that the wheel is at a perpendicular angle to the material being cut
• Keep a light touch, as the wheel will break under too much pressure, if chattering occurs, increase speed
• Plastics require very slow speeds, because they tend to melt at the contact point, wood requires low speeds also, always experiment on a scrap first

Cut-off wheels - fiberglass reinforced 1 1/4 inch diameter 0.045 inch thick Fiberglass reinforced, use for slicing and cutting metal, wood and plastic. Do not attempt to sand or cut curved holes. Do not run in excess of 30,000 RPM. Use with No.402 mandrel.

The 426 cut-off wheel is reinforced with fiberglass for increased durability and used for cutting metal including hardened steel. Cut-Off wheels make it easy to cut bolts or screws or make slots in rusted or stripped bolts and screws for removal with a screwdriver. Fiberglass reinforced, use for slicing and cutting metal, wood and plastic. Do not attempt to sand or cut curved holes. Do not run in excess of 30,000 RPM. Use with No.402 mandrel.