Belwith 1050 First Watch Security Adjust-A-Strike 1-1/4 By 4-7/8 For Dead Latch Polished Brass

4-7/8 inch, adjust-a-strike adjustment provides snug fit of door to jamb, stops door rattle, assures engagement of dead latch function, can be used on residential or commercial frames.

Instructions:Before starting first check door thickness for proper template alignment and then follow installation instructions.-If door thickness is 1-3/4″ place template on from 3/16″ from door jamb.-If door thickness is 1-3/8″ place template on the door jamb.

1. Remove old strike.2. Center template with latch hole and tape in place.3. Position new strike in place and mark two holes. Chisel out area behind strike if needed or a flush fit is desired.4. Drill 1/8″ pilot holes 2″ deep. Adjust to fit door.